Rule LoPro 900gph Bilge Pumps

Rule LoPro Bilge Pumps are small enough to fit into tight spaces in your Bilge, yet pack real pumping power at 900 gallons per hour - that's 3,400 litres an hour, 57 litres per minute.

These new pumps have numerous features that make them easy to install and easy to use.

There are 2 different models available: Manual Switched LP900D LoPro Pump, or the dual sensing Auto Operation LP900S LoPro Pump.

• Output: zero lift: 900gph/3407lph. 1m lift:634gph/2400lpg. 2m lift: 418gph/1582lph
• Compact size: 60mm high (with Port to the side), 60mm wide (with Port upright)
• Fully submersible - horizontal or vertical mounting
• Ignition protected - won't create a spark
• Thermal cut-out to prevent overheating if run dry
• Silicone blocked tinned 16 gauge wiring
• Rotating discharge body swivels 180 degrees for ease of installation
• Threaded discharge nozzle with multiple hose ports included
• Straight discharge ports include a nitrile non-return check valve (for use on straight ports only - not to be used on 90 degree port)
• Type approvals CE ISO 8849 Marine electric Bilge Pumps ISO8846 Marine ignition protection
• Supplied with: 19mm straight & elbow hose barbs, 25mm straight hose barb, 28mm hose barb

Standard LoPro Pump - Manual

• All features listed above
• 12 volt 4 amp (use a 7.5 amp fuse)
• If you need to make it automatic, a float switch is required.

Automatic LoPro Pump

• No flow switch required
• High or low water sensing mode - Pump can be set to start operation at either 33mm or 50mm Bilge water height
• Electronic automatic timer mode - Pump can be set to automatically check for water every 2.5 minutes. If water is present, it will continue to run and pump Bilge water. However, if you leave the Boat unattended on a Mooring, it may run down the battery over time if you don't have solar panels or a wind generator etc to constantly charge it. In this case, only set the pump to high or low mode.
• Includes pump test mode
• Includes manual override third wire - requires a Rule 3 Way panel switch to operate this feature
• 12 volt 4 amp (use a 7.5 amp fuse)
• 12 volt DC only - DO NOT run direct off a 240v - 12v transformer